It looks like we don't have any community posts for this product right now — Got relevant content to contribute?
About Highsider CBW1 Can-Bus Resistor
Highsider CBW1 Can-Bus Resistor
- Our newly developed Highsider CBW1 CAN-BUS Resistor is suitable for most vehicles equipped with a CAN-BUS system. The resistor provides a required electrical load for your vehicle, which if the DIP switches are set correctly does not lead to an error message with accessory turn signals.
- The following resistance values can be set: 150 Ohm, 170 Ohm, 200 Ohm, 240 Ohm, 300 Ohm, 400 Ohm, 600 Ohm, 1200 Ohm
- Up to 2 channels can be operated, such as rear left and rear right indicators
- If 2 pairs of indicators (VL,VR,HL,HR) are to be replaced, 2 x CBW1 are required
- Connections: Yellow wire = Input channel 1 (+),Orange wire = Output channel 1 (+),Blue wire = Input channel 2 (+),Red wire = Output channel 2 (+),Gray wire = Input ground (-),Black wire = Output ground (-)
- Note: Requirements for the use of the CBW1 on the vehicle: Either LED indicators were installed on the vehicle in their original condition or the vehicle has a CAN-BUS system.
Warning: California Proposition 65